I wanted to signify mine was a bit different by adding a badge from a Rapier H120 (as I'm running a Holbay from one). one went for £57 on ebay, so I thought I,d make one out of 3.2mm stainless, with 0.5mm backing. The insert was sourced from the S.R.O.C. for around a tenner!
Next to fit will be a Chromed Anti-roll bar. This has come out really well & after sourcing new Superflex polyurethane bushes, should perform better & look good as well! http://www.superflex.co.uk/
Below shows it fitted, the end 2 bolts were a pig, but there was only going to be one winner! Its on.
